SnowDayPlanner

Free snow day probability calculator with live weather data and a fully transparent scoring formula.

Rain to Snow Calculator

Forecasts talk in rain — inches of liquid. Schools close for snow. This rain to snow calculator converts one into the other using the National Weather Service ratio table, so you can turn tonight's liquid forecast into a snowfall number and feed it to the snow day calculator.

That falls as about

10.0 in of snow

Ratio used: 10:1 — Wet, heavy snow — the classic 10:1 snow. It packs, sticks to trees and is the branch-breaking kind.

That is squarely snow-day range for most districts if it falls overnight — run your ZIP through the main calculator for the real score.

Estimate from the National Weather Service snowfall-to-meltwater conversion table. Real storms vary with crystal type, humidity and wind — treat this as the planning number, not a guarantee.

How much snow is 1 inch of rain?

The famous answer is 10 inches — the 10:1 rule, one inch of liquid for every ten inches of snow. It is the right answer for exactly one kind of storm: a near-freezing one, around 28–34°F, where flakes are big, wet and dense. Colder storms play by different maths. At 22°F the same inch of water stretches to about 15 inches of snow; at 12°F, to roughly 30 inches of dry powder. Observational studies have recorded ratios from about 3:1 (slush at the freezing point) all the way to 100:1 (extreme polar powder). The ratio — the snow-to-liquid ratio, or SLR — is the single most important number hiding inside a winter forecast, and it is why forecasters quote precipitation as liquid in the first place: it is the only figure that stays honest across rain, snow and ice.

The NWS rain-to-snow ratio table

The calculator above uses the National Weather Service's snowfall-to-meltwater conversion table — the standard bands meteorologists and emergency managers plan with, also published as the FAA's snowfall conversion table:

Air temperatureRatioSnow type1 inch of rain becomes
28–34°F (−2 to 1°C)10:1Wet, heavy10 in (25 cm)
20–27°F (−7 to −3°C)15:1Average storm snow15 in (38 cm)
15–19°F (−9 to −7°C)20:1Light and fluffy20 in (51 cm)
10–14°F (−12 to −10°C)30:1Dry powder30 in (76 cm)
0–9°F (−18 to −13°C)40:1Very dry powder40 in (102 cm)
−1 to −20°F (−18 to −29°C)50:1Arctic powder50 in (127 cm)
Below −20°F (below −29°C)100:1Extreme polar powder100 in (254 cm)

Above 34°F the table ends: precipitation reaches the ground as rain, and the snow total is zero no matter how much liquid falls.

Why does temperature change the ratio?

Snowflakes grow in a layer of the cloud where temperature and humidity decide their shape. Near freezing, crystals grow large, branchy and sticky, gathering supercooled water droplets as they fall — heavy, dense snow with little air in it. In deep cold, crystals stay small and simple, stacking loosely with far more air between them. Wind matters too: strong wind fractures falling flakes into fragments that pack tighter, dragging the ratio down. The National Weather Service explains snow ratios the same way its forecasters use them — including why the ratio can change dramatically inside a single storm as temperatures move.

What does the converted number mean for snow days?

This is where the conversion earns its keep. A forecast calling for “0.6 inches of precipitation” sounds like a rainy nothing — until you run the ratio. At 25°F that is 9 inches of snow, deep into closure range for most districts if it lands overnight. At 31°F it is 6 inches of wet cement that plows handle and schools often absorb. Same liquid, opposite mornings. Once you have the snowfall figure, the rest of the decision is timing and temperature: run your ZIP through the main snow day calculator for the live score, check tomorrow's snow day chances for the morning view, and if the storm comes with bitter wind, pair this with the wind chill calculator — districts weigh the feels-like temperature alongside the depth, as our Michigan page shows zone by zone.

Frequently asked questions

How do you convert rain to snow?

Multiply the liquid amount by the snow-to-liquid ratio for the storm's temperature: snow depth = rain × ratio. At 30°F the ratio is about 10:1, so 1 inch of rain becomes roughly 10 inches of snow. At 22°F the ratio rises to 15:1 and the same inch of water becomes 15 inches of snow.

Is the 10:1 rule accurate?

Only near freezing, where it comes from. The National Weather Service points out that ratios vary enormously — observational studies have recorded everything from about 3:1 to 100:1 — and its La Crosse office notes a 12:1 ratio may be more representative on average for the Upper Midwest. Use 10:1 as a first guess, then adjust for temperature with the table on this page.

How much snow is half an inch of rain?

It depends entirely on temperature. Half an inch of liquid makes about 5 inches of snow at 30°F (10:1), 7.5 inches at 22°F (15:1), 10 inches at 17°F (20:1) and 15 inches at 12°F (30:1). That spread is exactly why two storms with identical rain forecasts can close school in one town and barely dust another.

Why did the forecast say 1 inch of precipitation but we got 14 inches of snow?

Because the forecast's 1 inch was liquid — the water content, called QPF by forecasters. Your storm ran colder than a 10:1 storm, at roughly a 14:1 ratio, so that inch of water arrived as 14 inches of snow. Forecasts quote liquid because it is the one number that works for rain, snow and ice alike.

What is snow water equivalent (SWE)?

The same conversion read backwards: SWE is how much water you get by melting the snow. Ten inches of 10:1 snow hold 1 inch of water. Hydrologists track SWE in the snowpack to forecast spring flooding and water supply; this calculator's reverse trip — snow depth divided by the ratio — gives the SWE of a fresh fall.

Does rain falling on existing snow add to the snow total?

No — rain on snow does the opposite. It compacts the pack, melts some of it and adds weight rather than depth. That is a roof-load and flooding problem, not a snowfall problem; our snow melt calculator estimates how fast a pack disappears in those conditions.

⚠️ SnowDayPlanner gives estimates from weather data only. Your school district makes the final call on closures — always confirm with official district announcements.

About the SnowDayPlanner Team

The SnowDayPlanner Team runs the snow day prediction model behind this site, combining live forecast data — snowfall, ice, wind chill and timing — with the closing patterns of thousands of school districts and boards. We publish how the model works and how accurate it has been, and we refresh predictions through the night as forecasts change, so the score you check in the morning reflects the latest data.

How the calculator works·Our accuracy record